Skip to content
New service bracket on a Freshwater cottage
Level 2 electrical

Point of Attachment Upgrade Northern Beaches

New galvanised brackets and raisers, moved clear of new decks, upper floors and re-roofs.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

The point of attachment is where the line from the street or a private pole fixes to your home. On the Northern Beaches that might be a wall bracket on a rendered two-storey home in Dee Why, or a steel raiser through the roof of a fibro cottage in Narrabeen. It holds the full mechanical load of the line, including in storms. When it rusts, or a renovation puts a deck or an upper floor too close, it needs replacing or moving, and that’s Level 2 work.

When it needs doing

Rust. Raisers and brackets near the surf corrode, especially where they pass through roof sheeting or meet the wall.

House raises. Lifting a beach house to add a ground floor changes every height on the building.

Second storeys and decks. New floors, balconies and decks must keep a safe distance from the wire.

Re-roofs. When the roof is replaced, an old raiser is replaced with it.

Storm damage. A limb on the line can rip the bracket from the wall or bend the raiser.

Weatherboard, fibro and render

Peninsula homes are built from everything. Brackets on weatherboard and fibro must fix into the timber frame, not the cladding. On rendered masonry we choose fixings that suit the substrate. In every case the fitting has to carry the line’s tension in a gale.

Galvanised fittings

We use hot-dip galvanised brackets and raisers with stainless or galvanised hardware suited to coastal air. Avoiding mixed metals slows corrosion.

Moving it during a renovation

Ideally the new position is planned before framing. Tell us early and we’ll mark the spot with your builder, then install when the wall or roof is ready. If no compliant position works, an overhead to underground conversion is the alternative.

Mains at the same time

A moved attachment point usually means the mains have to be extended or replaced. A consumer mains upgrade on the same visit means one outage.

Scaffold and roofers

Roofers and scaffolders can’t work near a live line. We isolate for the job with a power disconnection and reconnection, then replace the raiser before reconnecting.

Storm damage

A bracket hanging off or a raiser bent over after a storm is urgent. Keep clear and call our emergency level 2 electrician number.

Paperwork

We lodge the Ausgrid notification and give you a certificate of compliance at the end.

Where we work

Bracket and raiser jobs come from all over the beaches, including cottages in level 2 electricians Narrabeen and homes in level 2 electricians Balgowlah.

Clearances in plain terms

The service wire must stay set distances from windows, balconies, decks, roofs, the ground and footpaths, so nobody can reach it. When a renovation brings any of those closer, the attachment point has to move. We measure every one before recommending a spot.

How the job runs

We isolate the supply, take the line off the old fitting, install the new galvanised bracket or raiser, adjust or replace the mains, re-attach and tension the line, then test, reconnect and certify. Most jobs take a few hours.

Party walls and boundaries

On duplexes and semis around Manly and Freshwater, the bracket can sit near a shared wall or boundary. We check the new spot works for both homes and that the wire doesn’t pass over next door’s roof where it shouldn’t.

After a painter finds a problem

Painters sometimes discover a loose or rusted bracket once old paint is stripped. If yours does, stop work near the line and book us in. We isolate, replace the fitting and reconnect so the wall can be finished safely.

Get a price

Send a photo of the bracket or raiser to the level 2 electricians Northern Beaches team.

Updated

The price depends on whether we replace or relocate the fitting, the wall or roof it fixes to, the height and access, and whether new mains go in at the same time. You'll have a fixed price before we book.

What good point of attachment upgrade looks like

Close-up of point of attachment upgrade on a home in the Northern Beaches area
What point of attachment upgrade looks like up close on a typical Northern Beaches area home.
Signs that point of attachment upgrade needs attention
Typical signs that it needs attention.

Point of Attachment Upgrade in the Northern Beaches: step by step

  1. Measure clearancesDistances to decks, windows, roof and ground checked.
  2. Pick the positionCompliant, strong and out of the way of the renovation.
  3. Isolate and replaceSupply made safe, new galvanised fitting installed.
  4. ReconnectLine re-attached, tensioned, tested and certified.

Point of Attachment Upgrade questions in the Northern Beaches

Something else on your mind? Call 02 9158 9937 and ask.

We're adding a deck at the front. Will the wire be too close?

It might. We measure the clearances and move the attachment point or take the line underground if needed.

Our roof raiser is rusted where it goes through the tin. Can it be fixed?

We replace the raiser and flashing together, ideally when the roof is being worked on.

Can the bracket go on a weatherboard wall?

Yes, fixed into the frame with suitable hardware, not just the cladding.

Need Level 2 electricians on the Northern Beaches?

📞 Call now Free quote